start page | rating of books | rating of authors | reviews | copyrights

sendmail

sendmailSearch this book
Previous: 31.1 Preassigned Macros Chapter 31
Defined Macros
Next: 31.3 Configuration File Definitions
 

31.2 Command-Line Definitions

Macros may also be declared when sendmail processes its command line, by using either the -M command-line switch or the M option (see Section 34.8.77 ). The forms for these command-line declarations are

-oM

Xtext                


<- no longer recommended
 -M

Xtext                 


<- preferred as of V8.7

For both forms, the X is the macro name, which can be single-character or multicharacter (we discuss this soon). The text follows the name and is the value assigned to the macro.

In the first form, the -o switch tells sendmail that this is an option. The M is the name of the option. The M option causes sendmail to use the characters that follow the M as a macro definition. This form still works but may be eliminated in a future version of sendmail .

In the second form, the -M command line switch causes sendmail to use the characters that follow the M as a macro definition. Beginning with V8.7 sendmail , this is now the preferred form.

Because these forms of definition are a part of the command line, all special characters are interpreted by the shell. Any text that contains shell wildcard or history characters should be quoted. (We'll cover this in detail soon.)

Command-line macros are defined before the configuration file is read and parsed by sendmail . Note that configuration-file macros always override command-line macros. [3] Despite this, command-line definitions may still be useful. Preassigned macros may be given new values, and user-defined macros may be initialized in the command line.

[3] If you are running a pre-V8 version of sendmail , it may use a freeze file. In that case, command-line macros override those in the configuration file.

For security reasons, only the r and s macros [4] allow sendmail to retain its root privilege. Overriding the value of any other macro from the command line causes sendmail to run as an ordinary user.

[4] For V8 sendmail , r and s should be set with the -p command-line switch (see Section 36.7.32, -p ).

31.2.1 Syntax of the Command-Line Macro's Text

When a macro is declared on the command line, its text value is taken from the command line as is:

-M

Xtext

 -oM

Xtext

Unlike macros declared in the configuration file (which we describe next), this form of declaration does not strip commas from text nor does it handle escape characters.

The whole suite of special operators available to your shell may be used to generate an appropriate text value. For example, the following assigns the name of your Usenet news server to the macro N :

-MN$NNTPSERVER

The $NNTPSERVER is the shell's environmental variable that contains the address of the news server as its value.


Previous: 31.1 Preassigned Macros sendmail Next: 31.3 Configuration File Definitions
31.1 Preassigned Macros Book Index 31.3 Configuration File Definitions